Welcome Winter Lantern

Materials

• 15-0200 Armour Etch Glass Etching Cream
• 21-1751 Over N Over Stencil- WELCOME WINTER
• Small Lantern with Glass Panes

Additional Materials

• Soft Paper Towels
• #15-0315 Glass Cleaner
• #08-9606 Brushes
• #08-9999 Gloves
• #08-9415 Masking Tape

Directions

Preparation and Usage Starting Skills

• Over N Over Stencil Usage Instructions
• Armour Etch Usage Instructions

Project Steps

1. Clean the glass thoroughly with a good quality glass cleaner. If the glass cannot be removed from the lantern, cover the gap between the exterior glass and the frame with electrical style tape to prevent rinse water from sneaking inside later. Do this for any other open areas where water might seep in. Use masking tape, as usual, for the rest of the process.
2. Apply the desired stencil to the outside glass of the lantern. To etch more than one pane at a time with the same stencil, multiple sheets will be required. Otherwise, etch the panes one at a time.
3. Follow the etching cream instructions to apply the etching cream.
4. Because the glass is embedded in the lantern, use a brush to gently remove as much cream as possible before rinsing. This will abbreviate the amount of time under running water and further reduce the chance of rinse water getting where you don’t want it.
5. Rinse the cream off completely before removing tape and stencils