Santa Lights Bottle

Materials

• 15-0200 Armour Etch Glass Etching Cream
• 21-1689 Over N Over Stencil-COOKIES FOR SANTA
• 21-1732 Over N Over Stencil-CHRISTMAS ORNAMENTS 2
• 60-7031 Glass Bottle with Stopper

Additional Materials

• Soft Paper Towels
• #15-0315 Glass Cleaner
• #08-9606 Brushes
• #08-9999 Gloves
• #08-9415 Masking Tape

Directions

Preparation and Usage Starting Skills

• Over N Over Stencil Usage Instructions
• Armour Etch Usage Instructions

Project Steps

1. This design was etched in stages. The technique enables stencil images to be placed in closer proximity than the stencil borders would otherwise permit. It also allows the use of a particular stencil image multiple times on the same project when you don't have enough to etch all simultaneously.
2. After preparing the glass, place the Santa stencil on the front of the bottle in a location that allows enough room for the diagonal rows of lights to be added later.
3. Follow the etching cream instructions to etch the Santa onto the bottle.
4. Thoroughly clean the design area. Lay the string lights stencils on a diagonal above and below Santa’s head. Look through the back of the bottle to confirm there is no stencil overlap with the design already on the bottle. To etch both rows simultaneously, two stencil sheets are required. Otherwise, etch the string light rows one at a time.
5. Use the etching cream, as before, to etch the lights onto the bottle.