Lotus Pond Iceberg

Materials

• 15-0200 Armour Etch Glass Etching Cream
• 21-1696 Over N Over Stencil-NAMASTE
• 21-1605 Over N Over Stencil-BUTTERFLY BORDER
• Glass Iceberg

Additional Materials

• Soft Paper Towels
• #15-0315 Glass Cleaner
• #08-9606 Brushes
• #08-9999 Gloves
• #08-9415 Masking Tape

Directions

Preparation and Usage Starting Skills

• Over N Over Stencil Usage Instructions
• Armour Etch Usage Instructions

Project Steps

1. After preparing the glass, position the lotus stencil on the front of the iceberg so it is just above the water ripple on the bottom of the iceberg. Turn the iceberg over and place the plants on either side of the lotus image on front. Check both sides of the glass to make sure the images don’t overlap.
2. Choose a location near the lotus on the front of the glass and place a butterfly from the banner there. Press it down firmly. The remaining images on the banner will be covered by masking tape.
3. Follow the etching cream instructions to etch these onto the iceberg.
4. On the back of the glass, above the lotus, place 2 more butterflies from the banner stencil by bending the stencil and taping over the unwanted parts. This can also be accomplished by etching the butterflies from the banner one at a time.
5. Use the etching cream, as before, to etch the butterflies onto the glass.