Horse Coaster Set
Drippy messes won't giddy-up and go all over your saloon with these horse coasters. Rustic your ranch with the Horses Over N Over Glass Etching Stencil Sheet and some Armour Etch Glass Etching Cream. With 9 horse related stencils in the sheet, you can make barn buster birthday gifts or prance some ponies in the powder room.
Materials
- 15-0200 Armour Etch Glass Etching Cream
- 21-1600 Over N Over Stencil-BLANK MATERIAL
- 21-1677 Over N Over Stencil-HORSES
- 25-4000 Pinstripe Tape
- 60-3909 Glass Coaster Set
- Natural Cord or Wwine
- Flat Silver Embellishments
Additional Materials
Directions
Preparation and Usage Starting Skills
Project Steps
- This design was etched in stages. The technique allows you to use a particular stencil image, like these horseshoes, multiple times on the same project when you don't have enough to etch all simultaneously.
- After preparing the glass, place the pinstripe tape down one side of the glass near the edge. On one or more, cut across the stripes and take out a section of the stripes large enough to fit a horseshoe.
- Cut a fence out of the blank sheet and place it next to the stripes on the glass as shown i the picture.
- Follow the etching cream instructions to etch the onto the glass.
- Turn the glass over so the stripes run down the left of the glass on the back.
- Place horseshoe stencils in the gaps on the stripes where there is one and anywhere on the stripes if there is not.
- Place a horse stencil next to the stripes.
- Follow the etching cream instructions to etch the onto the glass.
- Starting at the center of one side of the coaster, glue a piece of the twine all along the edge of the glass.
- Attach the flat silver embellishments over the spot where the twine ends meet.
Article Posted: 08/10/2017 10:25:14 AM