Happily Ever After Tealight

Materials

• #15-200 Armour Etch Glass Etching Cream
• #21-1676 Over N Over stencil-FAIRY TALES
• #21-1650 Over N Over stencil-HAPPILY EVER AFTER
• #21-1600 Over N Over stencil-BLANK
• Tall Tealight Set
• Small Sparkle Star Embellishments

Additional Materials

• Soft Paper Towels
• #15-0315 Glass Cleaner
• #08-9606 Brushes
• #08-9999 Gloves
• #08-9415 Masking Tape

Directions

Preparation and Usage Starting Skills

• Over N Over Stencil Usage Instructions
• Armour Etch Usage Instructions

Project Steps

1. After preparing the glass hurricane, place the Happily Ever After just above the reach of the candle flame. Place the castle centered directly above it. Place the flying fairy above and to the right of the castle. Add star stencils in the open space leaving an empty space for the starburst to be added later.
2. Follow the etching cream instructions to etch these onto the glass.
3. To make the starburst- without removing the backing sheet, cut a 1.5 inch square out of the blank sheet. Place the star end of the wand into the center of the square and trace it onto the blank. Use a hobby knife to cut out the star in the center. Carefully cut thin, rectangular lines around the star. See the starburst on the glass for reference.
4. Remove the square from the backing sheet leaving the star and rectangles behind. Place it in the location you want the starburst and use the etching cream as before to etch it onto the glass.
5. Glue star embellishments into your desired locations.